I started Step 7, and the first thing is to apply the adhesive panels to the front and back of the chassis. Its specific in the instructions to make certain the panels are flush with the bottom. The front panel went on perfectly. But I did the back panel next, and made certain again that the bottom edges were flush, but after it was in place it was obvious the holes didn't line up. I am really hoping this is not going to be an issue. But for the moment I am tired and headed to bed.
If the holes aren't perfectly aligned, isn't a prob, just use a round file and make it fit. The washer rings you will use to put the controls, inputs and so on will cover the part where you see the chassis!
ReplyDelete